New features in SPINDALIGN Version 1.04
                    ============================================


    - Improved stepping calculation in straightness. This was achieved by
      swaping the distance and transducer position screens. So the unit 
      "knows" if the  user wants to trun and changes the calculation method.

    - Transducer position in straightness ist displayed in 0°/180°. Use left/
      right arrow keys to change the position.

    - Introduced static supporting points in "spindle to bed" mode. While in
      results you can choose the static supporting point on either spindle with
      the left/right arrow keys. That's why you have to change the spindle side
      now with the enter/back keys. You'll see only one supporting point result
      for one spindle, also in report.

    - Introdruced a new F-Function. F82 measures the current internal 
      inclinometer angle and stores that value as 0.0°. Use this function to
      clibrate the internal to external inclinometer.
      NOTE1: This works only within a range of +/-7.5° to the theoretical 0°
             position.
      NOTE2: If you upgrade from 1.03 or below firmware version the system 
             setup will be reseted to factory defaults. Setup you device again
             after upgrade.

    - F70 (reference length for angles) moved to F6 for simpler usage.

    - Reflector or transducer can be moved in straightness.   

    - The angle is now displayed in thenth of degrees during measurement
      ranging from 0° to 359.9°. 

    - Error meassage added in straightness if not enough points were taken
      (Flashing "M"-Icon). 
  
    - Reference length (F6) is displayed when entering results and this mode is
      activated or if this mode is activated using F2. 

    - Language support for French.
  

Please send your comments to:
e-Mail: ali_sales@pruftechnik.com