OPTALIGN smart goes geometric. The measurement of straightness is now possible using OPTALIGN smart, the latest laser alignment system from PRÜFTECHNIK Alignment Systems. The application referred to as "smart straightness" is used whenever high accuracy is needed, such as in the positioning of bearings and shaft supports over long runs. The subsequent corrections are monitored LIVE. This new powerful application is available as stand alone as well as a cost effective add-on package.

• Quick set-up thanks to the new line wizard
• Dimensions editable in any phase of the measurement
• Possibility to measure line at different heights
• Extend function for surfaces with big displacements
• Auto-routing to facilitate the user in the measurement
• Result interpolation through the choice of up to 2 fixed points
• Manual or automatically calculated tolerance values
• Colour screen providing straightforward analysis of point tolerance condition
• Measurement table to check measurement repeatability
• Monitoring of the corrections through the LIVE MOVE function

• Measure straightness of machine beds
• Check for runout on moving slides
• Position bearings and shaft support
• Monitor surface deflection and bending
• Align long rail and track sections
• Measure deflection on rams, actuators and extrusion presses
• Align roll profiles

• Available as cost effective upgrade for existing OPTALIGN smart customers
• Bluetooth wireless data transmission
• Manual and automatic tolerance value
• Repeatability check with the measurement table
• LIVE MOVE to monitor correction points
• Device generated customizable reports
  

  Request further information