| A unique service for alignment of a
wide size range of gas, steam, and hydro turbines is available
via the specialists PRÜFTECHNIK Service turbine alignment team.
Our services include:
- Turbine centerline tops on and tops off
- Diaphragms
- Bearing pedestals
- Glands
- Frames
- Couplings
- Rotors
- Shaft straightness & flatness
- Shaft plumbness on vertical turbines
- Inner and outer casing
- Continuous laser monitoring & thermal growth
Our guarantees:
Perfect alignment using PRÜFTECHNIK alignment systems,
supported by our knowledge and experience, offers:
- Improvement in efficiency of turbine units
- Cuts down the duration of overhauls
- No necessity to install the rotors for measurements
- Corrections for each element are generated immediately
- Precise alignment (0,01 mm) in diameters ranging from 150
mm 7000 mm, which is impossible to reach using other methods
- Correct alignment of bearing shells without installing the
rotors
- Detection of deformations and ovalization of elements
- Optimal choice of centre-line for the whole machine units
with minimal correction values for each element
- No error in laser measurements due to second control
sensor monitoring and correcting any laser drift
PRÜFTECHNIK Service is a certified contractor to perform
laser measurements to turbines on behalf of leading turbine
manufacturers.
Improved efficiency, minimizing outages, and reducing the
overhaul duration form part of the benefits of laser alignment.
Our turbine alignment team is at hand to assist you in acquiring
these money saving benefits. |
